Anycubic Mono X / Mono SE Endstop Modification

Step 1

Printing the Endstop Extension

The Anycubic Photon & Photon S do not have enough z-height adjustment to compensate for the thickness of Fula-Flex, and a printable spacer will be needed.

Make sure to print and test the spacer before you install the magnet! Once installed, you cannot use your printer without the spacer.

Anycubic Mono X

Anycubic Mono SE

Step 2

Installing the Spacer

Step 2.0/2.1

Anycubic Mono SE

Remove the two screws securing the trigger arm located beneath the gantry.

Re-Install with the printed spacer between the trigger arm and gantry as shown.

Now that the spacer is installed, we can move on to general installation.

Step 2.1/2.1

Anycubic Mono X